Korado Radik Combi VK Radiators | Technomec – Heating, Ventilation and Photovoltaic Solution

Steel panel radiator for combined heating

RADIK COMBI VK is a panel radiator in a VENTIL KOMPAKT design allowing a right bottom connection to the heating system distribution. It is designed for the pressurized heating systems.

RADIK COMBI VK is designed for a combined installation with the electric heater. This combination creates a panel radiator suitable for combined heating (hot water – electricity) and can be used independently of the operation of the heating system. From the view of the electric installation the electric heater does not require any special arrangements in the heated room. It is recommended to install it together with the installation of the radiator.

There are two upper and two bottom hangers welded on the rear side. The standard set contains an air vent, 2 pieces of blanking plugs, a valve with a pre-set flow rate covered by a plastic cap

Technical Data

Height (H) 500, 600 mm

Length (L) 800, 1000, 1200, 1400, 1600 mm

Depth (B)

- Type 22 COMBI VK 100 mm

Connecting pitch 50 mm

Connecting thread 5 × G½ inside

Highest allowed working pressure 10 bar

Highest allowed working temperature (°C) 110 °C

Radiator connection right bottom

Pressure Loss In case of two-pipe heating system it is necessary to calculate the correct level of valve presetting and specify this in the project documentation to ensure a proper function of the heating system. This must be kept by the installer during installation of the heating system.

In case of one-pipe heating system it is necessary to set the valve at level 6. For adjusting the required mass flow in the radiator we recommend to use the compact connecting fitting with a fixed or adjustable flow volume of water in the radiator.