Korado Radik Hygiene VK | Technomec – Heating, Ventilation and Photovoltaic Solution

Steel panel radiator for rooms with high demands on hygiene and cleanness, with flat front panel and right bottom connection

RADIK HYGIENE VK is a panel radiator in VENTIL KOMPAKT version which enables right bottom connection to the pressurized heating system.

It is suitable for installation and operation in rooms with high demands on hygiene and cleanness. All types are without convector fins; they have a flat front panel and the seam welds are covered with a special flat strip. The type 20S has got a bigger spacing between the panels (radiator depth B = 102 mm) as compared to the standard spacing of type 20 (B = 66 mm).

There are two upper and two lower hangers welded at the back side of the radiator. Radiators in length 1 800 mm and more have six hangers. An air-vent and blanking plugs are delivered as standard. We recommend using the drill-in brackets (type 18/120 – see the KORAMONT catalogue) which enable to mount the radiator in a distance of up to 65 mm from the wall.

Notice: If the requested distance between the radiator and the wall should be 65 ÷ 80 mm, the same type of brackets can be used on condition that the lower hangers are fixed with brackets (not with supporting pieces only). In such a case the additional brackets must be ordered extra.

Technical Data

Height (H) 503, 603 mm

Length (L) 404, 504, 604, 704, 804, 904, 1004, 1104, 1204, 1404, 1604, 1804, 2004 mm

Depth (B)

- Type 10 Hygiene VK 49 mm

- Type 20S Hygiene VK 102 mm

- Type 30 Hygiene VK 157 mm

Connecting pitch 50 mm

Connecting thread 6 × G½ inside

Highest allowed working pressure 10 bar

Highest allowed working temperature (°C) 110 °C

Radiator connection right bottom

Pressure Loss In case of two-pipe heating system it is necessary to calculate the correct level of valve presetting and specify this in the project documentation to ensure a proper function of the heating system. This must be kept by the installer during installation of the heating system.

In case of one-pipe heating system it is necessary to set the valve at level 6. For adjusting the required mass flow in the radiator we recommend to use the compact connecting fitting with a fixed or adjustable flow volume of water in the radiator.